Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the energy required to rupture coatings applied to pipe under specified conditions of impact from a falling weight.

1.2 This test method may involve hazardous operations and equipment. This test method does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this test method to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.3 The values stated in SI units to three significant decimals are to be regarded as the standard.

Keywords

Electrical measurements-coating applications; Falling weight test; Impact testing-pipeline coatings; Material handling; Penetration-pipeline coatings; Pipeline coatings; Point impact; Rupture/rupture strength; Shipping; Up and down method; Weight; pipeline coatings-impact resistance, by falling weight test; ICS Number Code 87.040 (Paints and varnishes)

To find similar documents by ASTM Volume:

06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)

To find similar documents by classification:

87.040 (Paints and varnishes Including coating powders, paint coatings and protective paint systems)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.