ASTM-G106 › Standard Practice for Verification of Algorithm and Equipment for Electrochemical Impedance Measurements
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers an experimental procedure which can be used to check one's instrumentation and technique for collecting and presenting electrochemical impedance data. If followed, this practice provides a standard material, electrolyte, and procedure for collecting electrochemical impedance data at the open circuit or corrosion potential that should reproduce data determined by others at different times and in different laboratories. This practice may not be appropriate for collecting impedance information for all materials or in all environments.
1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The availability of a standard procedure, standard material, and standard plots should allow the investigator to check his laboratory technique. This practice should lead to electrochemical impedance curves in the literature which can be compared easily and with confidence.
Samples of a standard ferritic type 430 stainless steel (UNS 430000) used to obtain the reference plots are available for those who wish to check their equipment. Suitable resistors and capacitors can be obtained from electronics supply houses.
This test method may not be appropriate for electrochemical impedance measurements of all materials or in all environments.
Keywords
ac impedance; algorithm verification; Bode; dummy cell; equipment verification; electrochemical impedance; electrochemical impedence spectroscopy; electrochemical measurement; Nyquist; polarization resistance; steel; ICS Number Code 71.040.40 (Chemical analysis)
To find similar documents by ASTM Volume:
03.02 (Corrosion of Metals; Wear and Erosion)
To find similar documents by classification:
71.040.40 (Chemical analysis Including analysis of gases and surface chemical analysis)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-STD-883Microcircuits
ASTM-G61
Standard Test Method for Conducting Cyclic Potentiodynamic Polarization Measurements for Localized Corrosion Susceptibility of Iron-, Nickel-, or Cobalt-Based Alloys
ISO-14644-2
Cleanrooms and associated controlled environments - Part 2: Monitoring to provide evidence of cleanroom performance related to air cleanliness by particle concentration
Document Number
ASTM-G0106-89R23
Revision Level
1989 R23 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
June 26, 2023
Document Type
Practice
Page Count
11 pages
Committee Number
G01.11