Document Center is acquired by Nimonik

Scope

1.1 This test method establishes the procedures for determination of both dimension (length and width) and squareness of resilient floor plank. This test method is intended for use with rectangular plank up to 36 in. (915 mm).

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are provided in applicable sections of this test method.

1.2 The values stated in inch-pounds units are to be regarded as the standard. The values given in parentheses are for information only.

Significance and Use

The combination of both dimensional and squareness of resilient floor plank is an important consideration because installed flooring may exhibit an objectionable appearance when either or both characteristics deviate from established tolerances. This test method provides a means of determining actual dimensional and squareness by using a single apparatus and procedure.

Keywords

ICS Number Code 79.080 (Semi-manufactures of timber)

To find similar documents by ASTM Volume:

15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)

To find similar documents by classification:

79.080 (Semi-manufactures of timber Including parquet, wood paving, handles, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.