Document Center is acquired by Nimonik

Scope

1.1 This specification covers the acceptance testing of insulated and insulating hand held tools used for working on, or in close proximity to, energized electrical apparatus or conductors operating at maximum voltage of 1000-V ac or 1500-V dc.

1.2 The use and maintenance of these tools is beyond the scope of this specification.

1.3 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

1.4 The following precautionary caveat pertains to the test method portion only, Section 7 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4.1 This specification does not purport to address all of the safety problems associated with the use of tools on, or in close proximity to, energized electrical apparatus.

Keywords

electrical power systems; electrical protective equipment; hand tools; insulated hand tools; performance-consumer products; tools; insulated hand tools; ICS Number Code 13.260 (Protection against electric shock. Live working); 25.140.01 (Hand-held tools in general)

To find similar documents by ASTM Volume:

10.03 (Electrical Insulating Liquids and Gases; Electrical Protective Equipment)

To find similar documents by classification:

13.260 (Protection against electric shock. Live working Including tools for working with voltages)

25.140.01 (Hand-held tools in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.