ASTM-D5179 › Historical Revision Information
Standard Test Method for Measuring Adhesion of Organic Coatings in the Laboratory by Direct Tensile Method
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the laboratory determination of organic coating adhesion to plastic substrates by mounting and removing an aluminum stud from the surface of the coating and measuring the force required to break the coating/substrate bond with a tensile tester.
1.2 This test method requires that the aluminum stud be glued directly to the surface of a coated, cured panel (Fig. 1).
1.3 This test method is used to compare the adhesion of coatings to various plastic substrates, thus allowing for a quantitative comparison of various coating/substrate combinations.
Keywords
adhesion; bond strength; cyanoacrylate adhesive; plastic substrate; pull-off strength; pull testing; tensile tester; ICS Number Code 25.220.60 (Organic coatings)
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D5179-97a
Revision Level
1997A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 10, 1997
Document Type
Test Method
Page Count
6 pages
Committee Number
D01.23