ASTM-D2855 › Standard Practice for the Two-Step (Primer and Solvent Cement) Method of Joining Poly (Vinyl Chloride) (PVC) or Chlorinated Poly (Vinyl Chloride) (CPVC) Pipe and Piping Components with Tapered Sockets
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice describes a procedure for making joints with poly(vinyl chloride) plastic (PVC) pipes, both plain ends and fittings, and bell ends, by means of solvent cements. These procedures are general ones for PVC piping. In non-pressure applications, simplified procedures may be used. Manufacturers should supply specific instructions for their particular products, if and when it seems necessary.
1.2 The techniques covered are applicable only to PVC pipe, both plain and bell-end, and fittings of the same classes as described in Specification D 1784.
1.3 Pipe and fittings are manufactured within certain tolerances to provide for the small variations in the extrusion, belling, and molding processes and are not to exact size. A partial list of standards for PVC pipe, fittings, and cements suitable for use in making solvent-cemented joints is given in Appendix X1.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 The text of this practice references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the practice.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Joints-pipe applications; Pipe fittings-PVC (poly(vinyl chloride; Plastic pipe/tubing/fittings-general; Poly(vinyl chloride)(PVC) fittings; Solvent cements for joining thermoplastic pipe/fittings; making solvent-cemented joints with (PVC) pipe/fittings
To find similar documents by ASTM Volume:
08.04 (Plastic Piping Systems)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A780Standard Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings
Document Number
ASTM-D2855-20R24
Revision Level
2020 R24 EDITION
Status
Current
Modification Type
Revision
Publication Date
Sept. 16, 2024
Document Type
Practice
Page Count
10 pages
Committee Number
F17.20