ASTM-A780 Standard Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings

ASTM-A780 - 2020 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Repair of Damaged and Uncoated Areas of Hot-Dip Galvanized Coatings
ORDER

Price:

$61.00        


Want this as a site license?

Scope

1.1 This practice describes methods which may be used to repair damaged hot-dip galvanized coatings on hardware, structural shapes, and other products fabricated prior to hot-dip galvanizing, and uncoated areas remaining after initial hot-dip galvanizing. The damage may be the result of welding or cutting (flame), in which case the coating will be damaged predominantly by burning. This practice can also be used to repair hot-dip galvanized coatings damaged by excessively rough handling during shipping or erection. Requirements concerning the renovation of uncoated areas remaining after initial hot-dip galvanizing are contained within the applicable material specification.

1.2 This practice describes the use of low melting point zinc alloy repair rods or powders made specifically for this purpose, the use of paints containing zinc dust, and the use of sprayed zinc (metallizing).

1.3 The extent of repair shall be limited to an area mutually agreeable to the contracting parties. Similarly, contracting parties shall agree to the repair method to be used.

1.4 This standard does not purport to address the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

Keywords

coatings-zinc; galvanized coating repair; galvanized coating; touch-up; zinc coating repair; zinc coatings; ICS Number Code 25.220.40 (Metallic coatings)

To find similar documents by ASTM Volume:

01.06 (Coated Steel Products)

To find similar documents by classification:

25.220.40 (Metallic coatings Including electrolytic depositions, cathodic coatings, autocatalytic coatings, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ACI-318
Building Code Requirements for Structural Concrete and Commentary

MIL-STD-454
Standard General Requirements for Electronic Equipment (Superseded by MIL-HDBK-454)

MIL-C-5541
Chemical Conversion Coatings on Aluminum & Aluminum Alloys

Document Number

ASTM-A780/A780M

Revision Level

2020 EDITION

Status

Current

Modification Type

Revision

Publication Date

Sept. 16, 2020

Document Type

Practice

Page Count

4 pages

Committee Number

A05.13