Document Center is acquired by Nimonik

Scope

1.1 This specification covers iron-base sintered metal powder, oil-impregnated bearings. There are two grades, depending on the level of combined carbon (see Table 1):

1.1.1 Grade 1, Iron Graphite -low combined carbon, and

1.1.2 Grade 2, Iron Graphite -high combined carbon.

1.2 The values stated in inch-pound units are the standard. The metric equivalents of inch-pound units may be approximate.

Note 1--Definitions of powder metallurgy terms can be found in Definitions B243. Additional useful information is available in the Related Material section of Vol 02.05 of the Annual Book of ASTM Standards .

Note 2--Information on design, permissible loads, dimensional tolerances, and recommended press fits and running clearances are provided in Appendix X1.

Keywords

density; iron graphite bearings; K strength constant; oil content; oil-impregnated; porosity; ICS Number Code 21.100.10 (Plain bearings)

To find similar documents by ASTM Volume:

02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)

To find similar documents by classification:

21.100.10 (Plain bearings)

To find similar documents by Federal Supply Class Code:

FSC 3120 (Bearings, Plain, Unmounted)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.