SS-ISO-5414-2 › Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Part 2: Connecting dimensions of chucks and designation (ISO 5414-2:2002, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 5414 specifies the dimensions of tool chucks (end mill holders) with clamp screws for tools with flatted cylindrical shanks in accordance with ISO 3338-2. It also specifies the designations of these chucks. Two types of connection are defined: ? chucks with 7/24 taper shanks in accordance with ISO 297 for manual changers and with ISO 7388-1 for automatic changers, for tool shanks with either single flat or a double flat for manual and automatic changers; NOTE 1 This part of ISO 5414 specifies the dimensions of tool chucks with 7/24 taper shanks No. 30 for automatic changers although these are not standardized. ? chucks with Morse taper shanks in accordance with ISO 296 and ISO 5413 for tool shanks with a single flat only. NOTE 2 The dimensions of the driving system of the tool shanks are dealt with in ISO 5414-1.
To find similar documents by classification:
25.060.20 (Dividing and tool-workpiece holding devices)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 5414-2:2006
Revision Level
2006 EDITION
Status
Current
Publication Date
Aug. 18, 2006
Language(s)
English
Page Count
12