SS-ISO-5414-1 › Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Part 1: Dimensions of the driving system of tool shanks (ISO 5414-1:2002, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 5414 lays down the dimensions of tool chucks (end mill holders) with clamp screws designed for driving flatted cylindrical shanks in accordance with ISO 3338-2 and specifies the clamp screws used. It also gives the maximum diameter of the chuck nose. This part of ISO 5414 defines two types of drive: - chucks with bores of d1 u 20 mm intended for driving cylindrical shank tools with a single flat, these tools being provided with either a single or a double cutting part; - chucks with bores of d1 W 25 mm intended for driving cylindrical shank tools with a double flat, these tools being provided with a single cutting part only. NOTE The connecting dimensions of the various types of chucks and the designation of tool chucks (end mill holders) with clamp screws are dealt with in ISO 5414-2.
To find similar documents by classification:
25.060.20 (Dividing and tool-workpiece holding devices)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 5414-1:2006
Revision Level
2006 EDITION
Status
Current
Publication Date
Nov. 24, 2006
Language(s)
English
Page Count
7