SS-ISO-3937-2 › Cutter arbors with tenon drive - Part 2: Dimensions of 7/24 taper (ISO 3937-2:2008, IDT)
SS-ISO-3937-2
-
2008 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 3937 specifies the dimensions of cutter arbors with tenon drive with 7/24 tapers. It also specifies the dimensions of cutter arbors with tenon drive and enlarged contact surface of the cutters. The interchangeability dimensions of the milling cutter bearing on the cutter arbor are in conformity with ISO 2780. The dimensions of the retaining screw used are specified in ISO 2780. 7/24 tapers are in conformance with ISO 297 for manual changing and with ISO 7388-1 for automatic changing.
To find similar documents by classification:
25.060.20 (Dividing and tool-workpiece holding devices)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 3937-2:2008
Revision Level
2008 EDITION
Status
Current
Publication Date
Dec. 8, 2008
Language(s)
English
Page Count
20
International Equivalent
ISO 3937-2:2008(IDT)