SS-ISO-10897 › Collets for tool holders with taper ratio 1:10 - Collets, holders, nuts (ISO 10897:2016, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies the dimensions, materials and manufacturing requirements, and designation of collets for tools with cylindrical shanks and their corresponding holders and nuts. For non-standardized clamping devices, such as clamping devices specified in drawings, these holders can be agreed upon between customer and supplier.Form A applies where a clamping range of H10 is sufficient.Form B can be used for any application without lateral cutting load.Annex A specifies the values for AT3 tolerance and AT4 tolerance.
To find similar documents by classification:
25.060.20 (Dividing and tool-workpiece holding devices)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 10897:2016
Revision Level
2016 EDITION
Status
Current
Publication Date
Sept. 8, 2016
Language(s)
English
Page Count
24
International Equivalent
ISO 10897:2016(IDT)