SS-ISO-10135 › Geometrical product specifications (GPS) - Drawing indications for moulded parts in technical product documentation (TPD) (ISO 10135:2007, IDT)
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This International Standard specifies rules and conventions for the indications of requirements for moulded parts on technical product documentation. It also specifies the proportions and dimensions of the graphical symbols used for this representation. NOTE The figures in this International Standard merely illustrate the text and are not intended to reflect actual application. Consequently, the figures are simplified and are not fully dimensioned and toleranced, showing only the relevant general principles applicable in any technical area.
To find similar documents by classification:
01.100.20 (Mechanical engineering drawings)
17.040.30 (Measuring instruments)
77.140.80 (Iron and steel castings)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-ISO 10135:2007
Revision Level
2007 EDITION
Status
Superseded
Publication Date
Dec. 11, 2007
Language(s)
English
Page Count
64
International Equivalent
ISO 10135:2007(IDT)