SS-EN-ISO-2538-2 › Geometrical product specifications (GPS) - Wedges - Part 2: Dimensioning and tolerancing (ISO 2538-2:2014)
SS-EN-ISO-2538-2
-
2014 EDITION
-
CURRENT
Document Center Inc. is an authorized dealer of SIS standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
This part of ISO 2538 specifies methods for the dimensioning and tolerancing of wedges.NOTE For simplicity, only truncated wedges have been represented in this part of ISO 2538; however, this document can be applied to any type of wedge.
To find similar documents by classification:
17.040.01 (Linear and angular measurements in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Designation Name
SS-EN ISO 2538-2:2014
Revision Level
2014 EDITION
Status
Current
Publication Date
Sept. 7, 2014
Language(s)
English
Page Count
28
International Equivalent
EN ISO 2538-2:2014(IDT); ISO 2538-2:2014(IDT)