MIL-P-55617 › Plastic Sheet, Thin Laminate, Metal Clad (for Printed Wiring, Primarily for Multilayer) (Superseded by MIL-P-13949)

MIL-P-55617 - REV B CANCELLATION 1 - CANCELLED -- See the following: MIL-P-13949
Show Complete Document History


Plastic Sheet, Thin Laminate, Metal Clad (for Printed Wiring, Primarily for Multilayer) (Superseded by MIL-P-13949)

Scope

This specification covers the requirements for fully cured, metal-clad, thin laminated, plastic sheets (see 6.1).  This specification applies to sheets when the base laminate does not exceed 0.031 inch in nominal thickness.  (For purposes of this specification, the term "metal-clad laminates" is used herein when referring to any of the types of plastic sheets.)

Notes

Claudia's Notes:
MIL-P-55617B with Amendment 1 was cancelled and replaced by MIL-P-13949 in March, 1981.  The specification was later renumbered MIL-S-13949, and then cancelled without replacement in November, 1998.


To find similar documents by Federal Supply Class Code:

FSC 5999 (Miscellaneous Electrical and Electronic Components)

 

Customers who bought this document also bought:

IPC/EIA-J-STD-001
Requirements for Soldered Electrical and Electronic Assemblies

MIL-STD-883
Microcircuits

QQ-P-35
Passivation Treatments for Corrosion-Resistant Steel (Replaced by ASTM-A967 and AMS-QQ-A-35)

ORDER



Document Number

MIL-P-55617

Revision Level

REV B CANCELLATION 1

Status

Cancelled

Publication Date

March 19, 1981

Page Count

1 page