ISO-8913 › Aerospace - Lightweight polytetrafluoroethylene (PTFE) hose assemblies, classification 400 degrees F/3 000 psi (204 degrees C/20 684 kPa) and 204 degrees C/21 000 kPa (400 degrees F/3 046 psi) - Procurement specification
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 8913:2006 specifies requirements for lightweight polytetrafluoroethylene (PTFE) hose assemblies for use in aircraft hydraulic systems at temperatures between - 55 °C and 204 °C (- 65 °F and 400 °F), and at a nominal pressure up to 3 000 psi (20 684 kPa) or 21 000 kPa (3 046 psi). The hose assemblies are also suitable for use within the same temperature and pressure limitations in aircraft pneumatic systems where some gaseous diffusion through the wall on the PTFE liner may be tolerated.
The use of these hose assemblies in high-pressure pneumatic storage systems is not recommended. In addition, installations in which the limits specified in ISO 8913:2006 are exceeded, or in which the application is not covered specifically by ISO 8913:2006, for example for oxygen, are subject to the approval of the purchaser.
A listing of hose assembly procurement standards conforming to ISO 8913:2006 is given.
To find similar documents by classification:
49.080 (Aerospace fluid systems and components)
83.140.40 (Hoses Hoses for general use, see 23.040.70)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ISO 8913:2006
Revision Level
3RD EDITION
Status
Current
Publication Date
Nov. 1, 2006
Committee Number
ISO/TC 20/SC 10