ISO-8283-4 › Plastics pipes and fittings - Dimensions of sockets and spigots for discharge systems inside buildings - Part 4: Acrylonitrile/butadiene/styrene (ABS)

ISO-8283-4 - 1ST EDITION - CURRENT


Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


Establishes a classification (ring-seal sockets and solvent cement sockets) and designation system (types S, M, L, and CS) for sockets and specifies the design formulae and the derived dimensions, together with tolerances, of these sockets and of spigots for joints and for integral sockets of ABS pipes intended for use in discharge systems inside buildings where such joints are intended to accommodate expansion and contraction.

ORDER

Price:

$78.57        


Want this as a site license?

To find similar documents by classification:

23.040.20 (Plastics pipes)

23.040.45 (Plastics fittings)

83.140.30 (Plastics pipes and fittings for non fluid use Plastics pipes, fittings and valves for general use, see 23.040.20, 23.040.45 and 23.060)

91.140.80 (Drainage systems Sewage water disposal and treatment, see 13.060.30 Drainage systems for rainwater, see 91.060.20 External sewage systems, see 93.030)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 8283-4:1992

Revision Level

1ST EDITION

Status

Current

Publication Date

Dec. 1, 1992

Committee Number

ISO TC 138/SC 1