ISO-286-1 › Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 1: Basis of tolerances, deviations and fits
Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
2ND EDITION - April 15, 2010
2ND EDITION CORRIGENDUM 1 - Aug. 1, 2013
2ND EDITION CORRIGENDUM 1 - Aug. 1, 2013
ISO 286-1:2010 establishes the ISO code system for tolerances to be used for linear sizes of features of the following types: a) cylinder; b) two parallel opposite surfaces.
ISO 286-1:2010 defines the basic concepts and the related terminology for this code system. It provides a standardized selection of tolerance classes for general purposes from amongst the numerous possibilities.
Additionally, it defines the basic terminology for fits between two features of size without constraints of orientation and location and explains the principles of “basic hole” and “basic shaft”.
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A967Standard Specification for Chemical Passivation Treatments for Stainless Steel Parts
ASME-Y14.5M
Dimensioning and Tolerancing (Correctly Numbered ASME-Y14.5)
ISO-9001
Quality management systems - Requirements
Document Number
ISO 286-1:2010
Revision Level
2ND EDITION
Status
Current
Publication Date
April 15, 2010
Committee Number
ISO/TC 213