ISO-14120 › Safety of machinery - Guards - General requirements for the design and construction of fixed and movable guards
The following bibliographic material is provided to assist you with your purchasing decision:
ISO 14120:2015 specifies general requirements for the design, construction, and selection of guards provided to protect persons from mechanical hazards.
ISO 14120:2015 indicates other hazards that can influence the design and construction of guards.
ISO 14120:2015 applies to guards for machinery which will be manufactured after it is published.
The requirements are applicable if fixed and movable guards are used. This International Standard does not cover interlocking devices. These are covered in ISO 14119.
ISO 14120:2015 does not provide requirements for special systems relating specifically to mobility such as ROPS (rollover protective structures), FOPS (falling-object protective structures), and TOPS (tip over protective structures) or to the ability of machinery to lift loads.
To find similar documents by classification:
13.110 (Safety of machinery This group includes standards for general use)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-D4169Standard Practice for Performance Testing of Shipping Containers and Systems
ASTM-F88
Standard Test Method for Seal Strength of Flexible Barrier Materials
ISO/IEC-16022
Information technology - Automatic identification and data capture techniques - Data Matrix bar code symbology specification
Document Number
ISO 14120:2015
Revision Level
2ND EDITION
Status
Current
Publication Date
Nov. 1, 2015
Committee Number
ISO/TC 199