ISO-10897 › Collets for tool holders with taper ratio 1:10 - Collets, holders, nuts

ISO-10897 - 2ND EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ISO standards.
The following bibliographic material is provided to assist you with your purchasing decision:


ISO 10897:2016 specifies the dimensions, materials and manufacturing requirements, and designation of collets for tools with cylindrical shanks and their corresponding holders and nuts. For non-standardized clamping devices, such as clamping devices specified in drawings, these holders can be agreed upon between customer and supplier.

Form A applies where a clamping range of H10 is sufficient.

Form B can be used for any application without lateral cutting load.

Annex A specifies the values for AT3 tolerance and AT4 tolerance.

ORDER

Price:

$78.57        


Want this as a site license?

To find similar documents by classification:

25.060.20 (Dividing and tool-workpiece holding devices)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ISO 10897:2016

Revision Level

2ND EDITION

Status

Current

Publication Date

Sept. 1, 2016

Committee Number

ISO/TC 29/SC 2