ISO-10360-6 › Geometrical Product Specifications (GPS) - Acceptance and reverification tests for coordinate measuring machines (CMM) - Part 6: Estimation of errors in computing Gaussian associated features
The following bibliographic material is provided to assist you with your purchasing decision:
Included in this current edition are the following subparts:
1ST EDITION CORRIGENDUM 1 - May 1, 2007
This part of ISO 10360 specifies a method for testing software used for computing associated features from coordinate measurements. The features of concern are the line (in two and three dimensions), the plane, the circle (in two and three dimensions), the sphere, the cylinder, the cone and the torus.
One or more separate tests are required for each feature claimed to be covered by the software.
The test is of the software alone and therefore independent of the coordinate measuring system.
This part of ISO 10360 is concerned with complete features and non-extremely partial features; however, the test for complete features and that for partial features are separate, and software may be submitted for either or both tests.
Cones with very large apex angles are not covered by the test.
To find similar documents by classification:
17.040.30 (Measuring instruments)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A580Standard Specification for Stainless Steel Wire
ASTM-E8
Standard Test Methods for Tension Testing of Metallic Materials
ASTM-E18
Standard Test Methods for Rockwell Hardness of Metallic Materials
Document Number
ISO 10360-6:2001
Revision Level
1ST EDITION
Status
Current
Publication Date
Dec. 15, 2001
Committee Number
ISO/TC 213