Document Center is acquired by Nimonik

Scope

1.1 This test method describes an experimental procedure for checking experimental technique and instrumentation. If followed, this test method will provide repeatable potentiostatic and potentiodynamic anodic polarization measurements that will reproduce data determined by others at other times and in other laboratories provided all laboratories are testing reference samples from the same lot of Type 430 stainless steel.

1.2 Values stated in SI units are to be regarded as the standard. Inch-pound units given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Anodic polarization measurement; Corrosion; Current measurement; Experimental technique/instrumentation; Instrumental measurement-corrosion; Potentiodynamic polarization; Stainless steel-corrosion testing; Steel; Surface analysis-metals/alloys; standard reference method for making potentiostatic/potentiodynamic; anodic polarization measurements, test,; Polarization resistance; making potentiostatic and potentiodynamic anodic polarization; measurements, test,; Polarized light

To find similar documents by ASTM Volume:

03.02 (Corrosion of Metals; Wear and Erosion)

To find similar documents by classification:

71.040.50 (Physicochemical methods of analysis Including spectrophotometric and chromatographic analysis)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.