Document Center is acquired by Nimonik

Scope

1.1 This specification establishes the requirements for wrought and fabricated shapes made from Copper UNS No. C10100, conforming to the chemical requirements of Specification B170, Grade 1, and suitable for use in electron devices.

1.2 The requirements of this specification are in addition to those prescribed in the following product specifications appropriate to the material being ordered: B1, B2, B75, B75M, B133, B133M, B152, B152M, B170, B187, B272 and B372. In case of conflict, however, this specification shall take precedence.

1.3 The inch-pound units are the standard for this specification except for grain sizes which are in metric units. Metric values given in parentheses are for information only.

1.4 The following safety hazard caveat applies to sections 17.4, 17.5 and 18.7 of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Copper-oxygen-free (deoxidized); Copper-rod/bar/shapes; Copper-tube; Copper alloy plate/sheet/strip/rolled bar; Copper alloy rod/bar/shapes; Copper alloy tube; Copper electrical conductors; Electronic materials/applications-Cu/Cu alloys; Metal electronic components/devices; Microscopic examination-electronic materials; Oxygen-free copper; Waveguides; Wrought Cu/Cu-alloy materials/applications; UNS C 10100; oxygen-free copper in wrought forms (for electron devices), spec; ICS Number Code 77.150.30 (Copper products)

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

77.150.30 (Copper products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.