Document Center is acquired by Nimonik

1.1 This safety specification is intended to define the test method and other requirements for tipover restraints as required in Specification F2057.

1.2 This specification assesses the strength of the tipover restraint only, and does not address the in situ performance of the tipover restraint.

1.3 The values stated in inch‐pounds units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following safety hazard caveat pertains only to the test procedure portion, Section 4, of this safety specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.