Document Center is acquired by Nimonik

1.1 This guide describes methods to contain the spread of hazardous materials that have been discharged into the environment. It is directed toward those emergency response personnel who have had adequate hazardous material response training.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

4.1 This guide contains information regarding the containment of a hazardous material that has escaped from its container. If a material can be contained, the impact on the environment and the threat it poses to responders and the general public is usually reduced. The techniques described in this guide are among those that may be used by emergency responders to lessen the impact of a discharge. Initial hazard assessment should be performed before applying mitigation techniques.

4.2 Emergency responders might include police, fire service personnel, government spill response personnel, industrial response personnel, or spill response contractors. In order to apply any of the techniques described in this guide, appropriate training is recommended. See OSHA Hazardous Waste and Emergency Response Standard (HAZWOPER) requirements.