ASTM-E831 Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis

ASTM-E831 - 2024 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis
ORDER

Price:

$69.00        


Want this as a site license?

Scope

1.1 This test method covers determination of linear thermal expansion of solid materials using thermomechanical analysis techniques.

1.2 This test method is applicable to solid materials that exhibit sufficient rigidity over the test temperature range such that the sensing probe does not produce indentation of the specimen.

1.3 The lower limit of coefficient of linear thermal expansion measured with this test method is 5 [mu]m/(m[dot]°C). The test method may be used at lower (or negative) expansion levels with decreased accuracy and precision (see Section 11).

1.4 This test method is applicable to the temperature range from -120°C to 600°C. The temperature range may be extended depending upon the instrumentation and calibration materials used.

1.5 Computer or electronic based instruments, techniques, or data treatment equivalent to this test method may also be used. Users of this test method are expressly advised that all such instruments or techniques may not be equivalent. It is the responsibility of the user to determine the necessary equivalency prior to use. In the case of dispute, only the manual procedures described in this test method are to be considered valid.

1.6 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Coefficient of linear thermal expansion; Expansion; Heating tests-plastics; Linear changes/linearity; Metals and metallic materials; Plastics (general); Solid phase materials-plastics; Thermal expansion/contraction-linear; Thermomechanical analysis (TMA); linear thermal expansion-solid materials, by thermomechanical analysis,; test; ICS Number Code 19.060 (Mechanical testing)

To find similar documents by ASTM Volume:

14.01 (Healthcare Informatics)

14.02 (General Test Methods; Forensic Psychophysiology; Forensic Sciences; Terminology; Conformity Assessment; Statistical Methods; Nanotechnology; Forensic Engineering; Manufacture of Pharmaceutical Products)

To find similar documents by classification:

19.060 (Mechanical testing Including testing equipment Mechanical testing of metals, see 77.040.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

MIL-STD-810
Environmental Engineering Considerations and Laboratory Tests

ASTM-D638
Standard Test Method for Tensile Properties of Plastics

ASTM-E8
Standard Test Methods for Tension Testing of Metallic Materials

Document Number

ASTM-E0831-24

Revision Level

2024 EDITION

Status

Current

Modification Type

Revision

Publication Date

May 7, 2024

Document Type

Test Method

Page Count

5 pages

Committee Number

E37.10