Document Center is acquired by Nimonik

Scope

1.1 This practice covers the reporting of particle size measurement data.

1.2 This practice applies to particle size measurement methods, devices, detail levels, and data formats for dry powders, and wet suspensions of solids, gels, or emulsion droplets. This practice does not pertain to liquid particles.

1.3 This practice does not concern particle concentration information.

1.4 This practice uses SI (Systeme International) units as standard. State all numerical values in terms of SI units unless specific instrumentation software reports particle size information, including percentiles, indices, and distributions as tabulations and graphs using alternate units. In this case, present both reported and equivalent SI units in the final written report. Refer to Practice E380 for proper usage of SI units.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

particle characterization; particle size; particle sie analysis; particle size characterization; particle size distribution; particle size report

To find similar documents by ASTM Volume:

14.02 (General Test Methods; Forensic Psychophysiology; Forensic Sciences; Terminology; Conformity Assessment; Statistical Methods; Nanotechnology; Forensic Engineering; Manufacture of Pharmaceutical Products)

To find similar documents by classification:

19.120 (Particle size analysis. Sieving Including test sieves and porosimetry)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.