ASTM-E1250 Standard Test Method for Application of Ionization Chambers to Assess the Low Energy Gamma Component of Cobalt-60 Irradiators Used in Radiation-Hardness Testing of Silicon Electronic Devices

ASTM-E1250 - 2015 R20 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Application of Ionization Chambers to Assess the Low Energy Gamma Component of Cobalt-60 Irradiators Used in Radiation-Hardness Testing of Silicon Electronic Devices
ORDER

Price:

$69.00        


Want this as a site license?

Scope

1.1 Low energy components in the photon energy spectrum of Co-60 irradiators lead to absorbed dose enhancement effects in the radiation-hardness testing of silicon electronic devices. These low energy components may lead to errors in determining the absorbed dose in a specific device under test. This method covers procedures for the use of a specialized ionization chamber to determine a figure of merit for the relative importance of such effects. It also gives the design and instructions for assembling this chamber.

1.2 This method is applicable to measurements in Co-60 radiation fields where the range of exposure rates is 7 X 10 -6 to 3 X 10 -2 C kg -1 s -1 (approximately 100 R/h to 100 R/s). For guidance in applying this method to radiation fields where the exposure rate is >100 R/s, see Appendix X1.

Note 1-See Terminology E170 for definition of exposure and its units.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Cobalt-60 irradiators; Electrical conductors-semiconductors; Electronic hardness; Electronic materials/applications; Gamma radiation; Hardness tests-radiation (of semiconductors); Ionizing radiation; Irradiance/irradiation; Low-energy gamma radiation; Photon energy spectrum; Radiation exposure-nuclear materials/applications; Radiation-hardness testing; Silicon-semiconductor applications; ionization chambers to assess the low energy gamma component of; cobalt-60 irradiators used in radiation-hardness testing of silicon; electronic devices, method; ICS Number Code 31.020 (Electronic components in general)

To find similar documents by ASTM Volume:

12.02 (Nuclear (II), Solar, and Geothermal Energy)

To find similar documents by classification:

31.020 (Electronic components in general Magnetic components, see 29.100.10)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-E1250-15R20

Revision Level

2015 R20 EDITION

Status

Current

Modification Type

Reapproval

Publication Date

July 31, 2020

Document Type

Test Method

Page Count

10 pages

Committee Number

E10.07