ASTM-D707 Standard Classification System and Basis for Specification for Cellulose Acetate Butyrate Molding and Extrusion Compounds (CAB)

ASTM-D707 - 2015 R23 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Classification System and Basis for Specification for Cellulose Acetate Butyrate Molding and Extrusion Compounds (CAB)
ORDER

Price:

$69.00        


Want this as a site license?

Scope

1.1 This specification covers requirements for plasticized cellulose acetate butyrate thermoplastic compounds suitable for injection molding and extrusion. These compounds have a butyryl content of not less than 35% and may or may not contain dyes and pigments. This specification does not include special materials compounded for special applications.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 The following safety hazards caveat pertains only to the test method portion, Section 12, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1- There is no equivalent ISO standard.

Keywords

acetate; butyrate; cellulose; extrusion; molding; plasticized; specification; ICS Number Code 83.080.20 (Thermoplastic materials); 83.140.99 (Other rubber and plastic products)

To find similar documents by ASTM Volume:

08.01 (Plastics (I): D256 - D3159)

To find similar documents by classification:

83.080.20 (Thermoplastic materials)

83.140.99 (Other rubber and plastics products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

 

Customers who bought this document also bought:

ASTM-E384
Standard Test Method for Microindentation Hardness of Materials

ASTM-A582
Standard Specification for Free-Machining Stainless Steel Bars

ASTM-D4066
Standard Classification System for Nylon Injection and Extrusion Materials (PA)

Document Number

ASTM-D0707-15R23

Revision Level

2015 R23 EDITION

Status

Current

Publication Date

March 17, 2023

Document Type

Specification

Page Count

5 pages

Committee Number

D20.15