Document Center is acquired by Nimonik

1.1 This test method is intended to be a mixing test used to identify or classify a slow-setting, SS or CSS, type of emulsified asphalt.

1.2 The values stated in SI units are to be regarded as standard. No other units of measure are included in this standard.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements for the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

3.1 The result of this test method indicates the ability of a slow-setting emulsified asphalt to mix with a finely divided, high-surface-area material (high early strength, Type III portland cement) without breaking the emulsified asphalt.