Document Center is acquired by Nimonik

Scope

1.1 These test methods cover procedures for determining the environmental performance properties of smooth-wall, coilable, medium-density and high-density polyethylene (MDPE and HDPE) conduit (duct) for preassembled wire and cable.

1.2 Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Environmental performance test values for smooth-wall, coilable, medium density and high density polyethylene (MDPE and HDPE) conduit (duct) for preassembled wire and cable may provide data for research and development, engineering design, quality control, and acceptance or rejection under specifications.

Keywords

compression and recovery; conduit; duct; high-density polyethylene; impact test; medium-density polyethylene; Compression testing--electrical insulating materials; Compression testing--plastics; Conduits; HDPE (high-density polyethylene); MDPE (medium density polyethylene); Polyethylene (PE) electrical insulation; Preassembled wire and cable; ICS Number Code 29.120.10 (Conduits for electrical purposes); 83.080.20 (Thermoplastic materials)

To find similar documents by ASTM Volume:

08.04 (Plastic Piping Systems)

To find similar documents by classification:

29.120.10 (Conduits for electrical purposes)

83.080.20 (Thermoplastic materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.