Document Center is acquired by Nimonik

Scope

1.1 This test method covers the determination of the percentage of water and other compounds volatile at about 100°C existing in a sample of sulfonated or sulfated oil, or both, by rapid evaporation. This test method is applicable only to sulfonated and sulfated oils that do not contain the following: mineral acids, free sulfonic acids or free sulfuric acid esters, ammonia, acetic acid or similar volatile acids, alkali hydroxides, carbonates, acetates or similar salts that may react with oleic acid at elevated temperatures liberating volatile acids, or glycerin, diethylene glycol, xylene, or other compounds of similar volatility. This test method was derived from Test Methods D500, Sections 10 through 14.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

hot plate method; leather; moisture content; sulfonated and sulfated oils; volatile content; ICS Number Code 75.080 (Petroleum products in general)

To find similar documents by ASTM Volume:

15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)

To find similar documents by classification:

75.080 (Petroleum products in general)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.