ASTM-D5199 Standard Test Method for Measuring the Nominal Thickness of Geosynthetics

ASTM-D5199 - 2012 R19 EDITION - CURRENT
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Measuring the Nominal Thickness of Geosynthetics
ORDER

Price:

$61.00        


Want this as a site license?

Scope

1.1 This test method covers the measurement of the nominal thickness of geosynthetics, except textured and some structured geomembranes where the entire surface of the presser foot cannot come into complete contact with the geosynthetic surface.

1.2 This test method does not provide thickness values for geosynthetics under variable normal compressive stresses. This test method determines nominal thickness, not necessarily minimum thickness.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

Thickness is one of the basic physical properties used to control the quality of many geosynthetics. Thickness values can be required for calculation of some geosynthetics properties such as permeability and tensile stress, among others.

The thickness of some geosynthetics may vary considerably with the applied normal load. Specific pressures and surfaces on which they are applied are indicated in this method to ensure all results are comparable.

This test method may be used for acceptance testing of commercial shipments of geosynthetics for which this method is applicable (see 1.1).

Note 1—The user should be aware that the compressibility of some materials, their rebound characteristics, and other phenomenon will affect the thickness of some geosynthetics, following the time when they are rolled up, shipped and stored.

Keywords

sample; selvage; specimen; Geomembranes; Geosynthetics; Nominal thickness; Selvage; Thickness--geosynthetics

To find similar documents by ASTM Volume:

04.13 (Geosynthetics)

To find similar documents by classification:

59.080.70 (Geotextiles Including geosynthetics)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D5199-12

Revision Level

2012 R19 EDITION

Status

Current

Modification Type

Revision

Publication Date

June 15, 2019

Document Type

Test Method

Page Count

4 pages

Committee Number

D35.03