Document Center is acquired by Nimonik

Scope

1.1 This test method describes a procedure for rapid evaluation of abrasives for the presence of ionic contamination by determining the total concentration of water soluble ionic contaminants by means of a conductivity test.

1.2 This test method does not identify the ionic species present nor provide quantitative results on each species.

1.3 This test method is based on a volume comparison among abrasives of similar sizes. A volume comparison is more closely related to surface area of the abrasives than is a weight comparison.

1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

ionogenic; contamination; steel surfaces; abrasive; blasting; conductimetric; analysis; interlaboratory testing; precision; chloride; conductivity; salts

To find similar documents by ASTM Volume:

06.02 (Paint -- Products and Applications; Protective Coatings; Pipeline Coatings)

To find similar documents by classification:

25.220.10 (Surface preparation Including surface preparation for painting, cleaning, scouring, blasting, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.