ASTM-D4507 Specification for Thermoplastic Polyester (TPES) Materials (Withdrawn 1999)

ASTM-D4507 - 1993A EDITION - SUPERSEDED -- See the following: ASTM-D5927
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Specification for Thermoplastic Polyester (TPES) Materials (Withdrawn 1999)

Scope

1.1 This specification covers thermoplastic polyester materials suitable for molding or extrusion.

1.2 This specification is intended to be a means of calling out plastic materials used in the fabrication of end use items or parts. It is not intended for the selection of materials. Material selection should be made by those having expertise in the plastics field after careful consideration of the design and performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the inherent properties of the material other than those covered by this specification, and the economics.

1.3 The properties included in this specification are those required to identify the compositions covered. There may be other requirements necessary to identify particular characteristics important to specialized applications. These will be agreed upon between the user and the supplier, by using the suffixes as given in Section 5.

1.4 The values stated in SI units, as detailed in Practice E380, are to be regarded as the standard.

1.5 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.

Note 1-This specification is similar to ISO7792/1-1985(E), although the technical content is significantly different.

Keywords

Fabrication; Material properties; Molding/extrusion compounds/materials; PET (poly(ethylene terephthalate)); Polyester plast; Thermoplastic polyester materials; Thermoplast; thermoplastic polyester (TPES) molding/extrusion materials; ICS Number Code 83.080.20 (Thermoplastic materials)

To find similar documents by ASTM Volume:

08.03 (Plastics (III): D5117 - latest; Reinforced Plastic Piping Systems and Chemical Equipment; Plastic Building Products)

To find similar documents by classification:

83.080.20 (Thermoplastic materials)

To find similar documents by Federal Supply Class Code:

FSC 9330 (Plastics Fabricated Materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-D4507-93a

Revision Level

1993A EDITION

Status

Superseded

Modification Type

Replaced

Publication Date

April 15, 1993

Document Type

Specification

Page Count

7 pages

Committee Number

D20.15