ASTM-D4370 › Historical Revision Information
Standard Test Methods for Acid and Base Milliequivalent Content of Electrocoat Bath
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the determination of acid and base milliequivalent contents of anodic and cathodic electrocoat baths and their ultrafiltrates.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
4.1 The acid and base concentrations are a measurement of the titratable acidic and alkaline components in the electrocoat baths. These measurements are used for research, production or electrocoat bath process control.
Keywords
acid content; base content; electrocoat baths; ICS Number Code 25.220.40 (Metallic coatings)
To find similar documents by ASTM Volume:
06.01 (Paint -- Tests for Chemical, Physical, and Optical Properties; Appearance)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D4370-01(2012)
Revision Level
2001 R12 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Aug. 1, 2012
Document Type
Test Method
Page Count
3 pages
Committee Number
D01.21