Document Center is acquired by Nimonik

Scope

1.1 These test methods are intended to determine the ability of a package or product to withstand laboratory simulated horizontal impact forces.

1.2 The horizontal impacts used in these test methods are programmed shock inputs that represent the hazards as they occur in the shipping and handling environments. The environmental hazards may include rail switching impacts, pallet marshalling impacts, and so forth. The following test methods apply:

1.2.1 Method A, Rail Car Switching Impact -This test method simulates the types of shock pulses experienced by lading in rail car switching, with the use of a rigid bulkhead on the leading edge of the test carriage, to simulate the end wall of a railcar and shock programming devices to produce representative shock pulses. With the use of backloading, this test method may also be used to simulate compressive forces experienced by lading loads during rail car switching. It is suitable for tests of individual containers or systems as they are shipped in rail cars. It may also be used to evaluate the effectiveness of pallet patterns to determine the effect of interaction between containers during rail switching operation impacts.

1.2.2 Method B, Pallet Marshalling Impact Tests -This test method assess the ability of single containers, systems, and unit load quantities to withstand the forces encountered during pallet marshalling or airplane loading operations.

1.3 The test levels may be varied to represent the mode on shipping and handling used for the item under test.

1.4 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 6.

Keywords

controlled; horizontal impact; pallet marshalling; rail car; switching; ICS Number Code 55.040 (Packaging materials and accessories)

To find similar documents by ASTM Volume:

15.10 (Packaging; Flexible Barrier Packaging)

To find similar documents by classification:

55.020 (Packaging and distribution of goods in general)

55.040 (Packaging materials and accessories Including wrappers, paper, films, foils, cords, sealing devices, cushioning, etc. Adhesive tapes for general purposes, see 83.180)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.