ASTM-D3708 › Standard Test Method for Weight of Wax Applied During Curtain Coating Operation (Withdrawn 2015)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the weight of hot melt coating applied to corrugated board by curtain coating. It is intended to be used for routine process control in the plant.
Note 1—Related methods for determining the weight of wax coating include the following: Test Method D3521; Test Method D3522, and Test Method D3344.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
Wax coatings are applied to corrugated board to provide a barrier against moisture or other penetrants or to provide improved appearance or abrasion resistance. These functional properties are influenced by the amount of wax present on the surface.
During curtain coating operations, major portions of the wax will congeal on the surface, while a minor portion will penetrate and become embedded in the fibers of the facing. This method measures the total weight of wax applied to the board. The amount actually remaining on the surface of the corrugated board can be determined by Test Method D3521.
The uniformity of application of wax film across the width of the curtain coater may also be determined using this technique by passing test combinations (blanks) under the curtain at various locations, that is, left side, center, right side.
Keywords
curtain coating; weight of wax; Curtain coatings; Petroleum wax; Wax coatings; Waxed paper/paperboard; ICS Number Code 85.060 (Paper and board)
To find similar documents by ASTM Volume:
05.01 (Petroleum Products and Lubricants (I): D56 - D3710)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D3708-88(2010)
Revision Level
1988 R10 EDITION
Status
Cancelled
Modification Type
Withdrawn
Publication Date
May 1, 2010
Document Type
Test Method
Page Count
2 pages
Committee Number
D02.10.0A