Document Center is acquired by Nimonik

Scope

1.1 This specification covers bale coating on bales of natural rubber (that have rubber wrapper sheets on the bales) and includes test method description. It specifies the maximum permissible amount of such coating.

1.2 This specification is not applicable to natural rubber that is packaged with plastic wrappers, as no bale coating is used.

1.3 The following safety hazards caveat pertains only to the test method portion, Section 5, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

ash method; bale coating; bareback bales; brushing method; mineral filler; natural rubber bales; ICS Number Code 83.040.10 (Latex and raw rubber)

To find similar documents by ASTM Volume:

09.01 (Rubber, Natural and Synthetic -- General Test Methods; Carbon Black)

To find similar documents by classification:

83.040.10 (Latex and raw rubber)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.