Document Center is acquired by Nimonik

1.1 This test method covers the recovery by the Abson method of asphalt from a solution from a previously conducted extraction. The asphalt is recovered with properties substantially the same as those it possessed in the bituminous mixture and in quantities sufficient for further testing.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are provided for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

4.1 The asphalt should be extracted from the aggregate-asphalt mixture in accordance with Method A of Test Methods D2172/D2172M (centrifuge method) or D8159 as there is some experimental evidence that the recovered asphalt may have slightly lower penetration values when recovered from solutions obtained from hot extraction methods.