ASTM-D1754 › Standard Test Method for Effects of Heat and Air on Asphaltic Materials (Thin-Film Oven Test)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of the effect of heat and air on a film of semisolid asphaltic materials. The effects of this treatment are determined from measurements of selected asphalt properties before and after the test.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
aging; asphalt cement; Thin Film Oven Test (TFOT)
To find similar documents by ASTM Volume:
04.03 (Road and Paving Materials; Vehicle-Pavement Systems)
To find similar documents by classification:
91.100.50 (Binders. Sealing materials Including geomembranes, asphalts for buildings, etc.)
93.080.20 (Road construction materials Including asphalts, road pavements, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
MIL-O-27210Oxygen, Aviators Breathing, Liquid & Gas (Now Numbered: MIL-PRF-27210)
MIL-STD-45662
CALIBRATION SYSTEMS REQUIREMENTS (REPLACED BY ISO-10012 and ANSI-Z540.3)
93/68/EEC
Amending Directives 87/404/EEC (Simple Pressure Vessels), 88/378/EEC (Safety of Toys),
Document Number
ASTM-D1754_D1754M-20
Revision Level
2020 EDITION
Status
Current
Modification Type
Revision
Publication Date
Nov. 6, 2020
Document Type
Test Method
Page Count
7 pages
Committee Number
D04.46