ASTM-D1570 › Standard Test Methods for Sampling and Chemical Analysis of Fatty Alkyl Sulfates
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover the sampling and chemical analysis of paste, powder, or liquid detergent fatty alkyl sulfates.
1.2 The procedures for sampling and analysis appear in the following order:
Sections Sampling: Powders and Flakes Packed in Cans or Cartons 4 Powders and Flakes in Bulk 5 Liquids 6 Pastes 7 Preparation of Sample 8 Moisture by the Distillation Test Method 11 to 14 pH 15 Alkalinity 16 to 19 Alcohol-Soluble Matter 20 to 22 Alcohol-Insoluble Matter 23 to 24 Unsulfated Material 25 to 28 Combined Alcohols 29 to 32 Ester SO1.3 The values stated in either inch-pound or SI units are to be regarded separately as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Material Safety Data Sheets are available for reagents and materials. Review them for hazards prior to usage.
Keywords
Acidity, alkalinity, pH-detergent materials; Alcohol content; Alcohol-insoluble matter content; Alcohol-soluble matter content; Chemical analysis-detergent materials; Chloride content-cleaning agents/detergents; Detergent materials/systems; Distillation; Esters; Fatty alkyl sulfates; Moisture analysis-detergent materials; Sodium sulfate content; Sulfate content-cleaning materials; Unsulfated matter content; fatty alkyl sulfates-sampling/chemical analysis, test
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
71.100.40 (Surface active agents)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-F1249Standard Test Method for Water Vapor Transmission Rate Through Plastic Film and Sheeting Using a Modulated Infrared Sensor
ASTM-E169
Standard Practices for General Techniques of Ultraviolet-Visible Quantitative Analysis
ASTM-E387
Standard Test Method for Estimating Stray Radiant Power Ratio of Dispersive Spectrophotometers by the Opaque Filter Method
Document Number
ASTM-D1570-95R23
Revision Level
1995 R23 EDITION
Status
Current
Modification Type
Revision
Publication Date
Aug. 1, 2023
Document Type
Test Method
Page Count
10 pages
Committee Number
D12.12