ASTM-D1290 › Standard Test Method for Sediment in Water-Emulsion Polishes by Centrifuge
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the determination of sediment in water-emulsion polishes by means of a centrifuge.
1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
3.1 This test method determines the amount of sediment in water-emulsion polishes. Sediment is generally believed to have negative effects on water-emulsion polish properties.
Keywords
centrifuge; polishes; sediment; water-emulsions ;
To find similar documents by ASTM Volume:
15.04 (Soaps and Other Detergents; Polishes; Leather; Resilient Floor Coverings)
To find similar documents by classification:
71.100.40 (Surface active agents)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-D1290-95(2015)
Revision Level
1995 R15 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Nov. 15, 2015
Document Type
Test Method
Page Count
2 pages
Committee Number
D21.03