Document Center is acquired by Nimonik

Scope

1.1 This test method covers the measure of flowability of chemical-resistant polymer machinery grouts as evaluated in a 2-in. (5-cm) or 1-in. (2.5-cm) pour thickness. The test method provides for the assessment of upper surface plate contact area (bearing area). These grouts will typically be two- or three-component formulations that may be used for installations where grout thickness will range from 1 to 6 in. (2.5 to 15 cm) underneath the base or plates being grouted.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.

Keywords

bearing area; chemical-resistant polymer machinery grout; flowability; surface contact; ICS Number Code 83.020 (Manufacturing processes in the rubber and plastics industries)

To find similar documents by ASTM Volume:

04.02 (Concrete and Aggregates)

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

83.020 (Manufacturing processes in the rubber and plastics industries)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.