Document Center is acquired by Nimonik

Scope

1.1 This test method covers procedures for testing precast concrete manhole sections when using the vacuum test method to demonstrate the integrity of the installed materials and the construction procedures. This test method is used for testing concrete manhole sections utilizing mortar, mastic, or gasketed joints.

1.2 This test method is intended to be used as a preliminary test to enable the installer to demonstrate the condition of the concrete manholes prior to backfill.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This test method is the companion to metric Test Method C 1244M; therefore, no SI equivalents are shown in this test method.

Note 1—Vacuum test criteria presented in this test method are similar to those in general use. The test and criteria have been widely and successfully used in testing manholes.

Note 2—It should be understood that no correlation has been found between vacuum (air) and hydrostatic tests.

Keywords

acceptance criteria; concrete; manhole sections; test method; vacuum test; ICS Number Code 23.040.50 (Pipes and fittings of other materials)

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

23.040.50 (Pipes and fittings of other materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.