ASTM-B747 › Historical Revision Information
Standard Specification for Copper-Zirconium Alloy Sheet and Strip
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the requirements for sheets and strips of copper-zirconium alloys with Copper Alloy UNS No. C15100. The material for manufacture shall be a cast bar, slab, cake, billet, or others of such purity and soundness as to be suitable for processing by hot working, cold working, and annealing to produce a uniform wrought structure in the finished product. Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (thickness, length, width, mass, straightness, and edges), mechanical (tensile strength, and hardness), electrical resistivity, chemical composition, and grain size requirements.
Scope
1.1 This specification establishes the requirements for sheet and strip of Copper Alloy UNS C15100.
1.2 Values stated in inch-pound units are the standard. SI values given in parentheses are for information only.
Keywords
copper-zirconium; sheet and strip; ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B747-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 1, 2007
Document Type
Specification
Page Count
5 pages
Committee Number
B05.01