ASTM-B719 › Historical Revision Information
Standard Specification for Nickel-Chromium-Molybdenum-Cobalt-Tungsten-Iron-Silicon Alloy (UNS N06333) Bar
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the standard for hot-finished and cold-finished UNS N06333 alloy bars and flats proposed for use in heat resisting applications and general corrosive service. Materials shall conform to mechanical properties of the material such as tensile strength, yield strength, elongation, and hardness. Each specimen will be subjected to a chemical analysis, tension, Brinell hardness, and Rockwell hardness test.
Scope
1.1 This specification covers wrought alloy UNS N06333 in the form of hot-finished and cold-finished bars and flats intended for heat resisting applications and general corrosive service.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses re mathematical conversions to SI units that are provided for information only and are not considered standard
Keywords
N06333; bar; ICS Number Code 77.120.40 (Nickel, chromium and their alloys)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.120.40 (Nickel, chromium and their alloys)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B719-00(2005)
Revision Level
2000 R05 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
May 1, 2005
Document Type
Specification
Page Count
5 pages
Committee Number
B02.07