Document Center is acquired by Nimonik

Scope

1.1 This specification covers the requirements for a coating of zinc mechanically deposited on iron and steel basis metals. The coating is provided in several thicknesses up to and including 107 [mu]m. The seven thickest classes are usually referred to as "mechanically galvanized."

1.2 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.3 The values stated in SI units are to be regarded as the standard. The inch-pound equivalents of SI units may be approximate.

Keywords

Coatings-mechanically deposited; zinc coatings on iron/steel metals, spec.,; Iron products (general)-mechanically deposited coatings; Steel products-mechanically deposited coatings; zinc coatings, spec.,; Zinc; mechanically deposited coatings on iron/steel metals, spec; ICS Number Code 25.220.40 (Metallic coatings)

To find similar documents by ASTM Volume:

02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)

To find similar documents by classification:

25.220.40 (Metallic coatings Including electrolytic depositions, cathodic coatings, autocatalytic coatings, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.