Document Center is acquired by Nimonik

Scope

1.1 This specification covers the requirements for several grades and types of electrodeposited copper plus nickel plus chromium coatings on plateable plastic substrates where appearance, durability and resistance to thermal cycling are important to service performance. Five grades of coatings are provided to correlate with the service conditions under which each is expected to provide satisfactory performance.

1.2 This specification covers the requirements for coatings applied subsequent to the application of metal film by autocatalytic deposition or subsequent to the application of any strike coatings after autocatalytic deposition.

1.3 The following caveat pertains only to the test method portions of Section 6, Annex A1, and Appendixes X2, X3, and X4 of this specification. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Coatings-decorative; Copper-nickel-chromium-electrodeposited coatings; Electrodeposited coatings; Electroplated coatings-plastic; Electroplated plast; Plast (general)-electrodeposited coatings; decorative electroplated coatings of copper/nickel/chromium on plast,; spec

To find similar documents by ASTM Volume:

02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)

To find similar documents by classification:

25.220.40 (Metallic coatings Including electrolytic depositions, cathodic coatings, autocatalytic coatings, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.