ASTM-B312 › Historical Revision Information
Standard Test Method for Green Strength of Specimens Compacted from Metal Powders
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers determination of the green strength of unsintered compacted metal powder specimens by subjecting them to a uniformly increasing transverse loading under controlled conditions. The term green strength, as used herein, defines the stress, calculated from the flexure formula, required to break a specimen as a simple beam supported near the ends and applying the force midway between the fixed line center of the supports.
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents are in parentheses and may be approximate.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
constant loading beam device; green strength; P/M; powder metallurgy; unsintered compact
To find similar documents by ASTM Volume:
02.05 (Metallic and Inorganic Coatings; Metal Powders and Metal Powder Products)
To find similar documents by classification:
77.160 (Powder metallurgy Including sintered metal materials and hardmetals)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B312-82(1988)e1
Revision Level
1982 R88(E1) EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Jan. 1, 1988
Document Type
Test Method
Page Count
4 pages
Committee Number
B09.02